This post shows the kind of works that can be done with a Kaiser Piccolo boring head. It includes the usual boring work but also the facing work usind the automatic travel of the head and an example of peg turning. The usual boring head tooling is also reviewed.

Continue reading

The Kaiser Piccolo is an exquisitely made mid sized boring head with boring and automatic facing functions. I got a ISO30 one in a very nice condition together with a bunch of tooling. When tested it performed very fine but I couldn’t switch easily between facing and boring (marked as P and A in the head, maybe for the french «planage» and «alésage»). It needs to be serviced to cope with this jam.

Continue reading

I bought in german ebay a four jaws independent chuck with DIN 55022 number 4 fitting. This was not the kind of independent chuck I prefer for the Leinen lathe. I would prefered those kind of “old” chucks which are lighter than the modern ones. Having found no provider for these lighter chucks, finally I went for this one. The chuck can be seen in this picture: The chuck was in pretty good condition.

Continue reading

The Leinen LZ4SB leadscrew is supported by two bearings. One of them, the corresponding to the adjusting end, has been eroded maybe for a deficient lubrication. This need to be faced again to recover the bearing surface. We plan to do that using a boring head on the milling machine. To support the part in an orthogonal position first an adjusting stud is turned in a lathe. This will guide the bearing when clamped to the table.

Continue reading