Wörner B13 alignment and geometry

October 14, 2020 in machine overhauling, wörner B13

In this post I show the result of carrying a sequence of tests to the rebuild Wörner drilling press to check its accuracy. I took an Aciera 10 drilling machine inspection chart as a reference. Both machines are of similar size and Aciera quality is second to none.

Wörner B13 cabinet and electrical wiring

September 14, 2020 in machine overhauling, Wörner B13

One of this summer works have been to finish the cabinet of the the Wörner B13 drilling press. It was mainly a work of covering the steel frame support with MDF. The final desire is to get it prepared to fit the electrical wiring and a set of drawers to organize the tooling of the machine.

Wörner B13 mechanics finished

June 22, 2020 in machine overhauling, Wörner B13

This is the post that closes the mechanic works on the Wörner B13. Now remains to do some final testing, some woodworking to take profit of the supporting structure and to mount the electrical controls. These will be the next steps. There are a couple of pictures of the finished machine:

A new return spring

June 22, 2020 in machine overhauling, Wörner B13

This is how the drilling machine return spring looks when I opened the cover: A previous owner did a not very successful repair and modified the internal attachment of the spring. As a result, spring was badly deformed and have a unusual feeling during the descent. I extracted it by pulling it out of the cup and then giving it a quarter turn to free the external end from its attachment (it has a rectangular shape as you will see next).

Rebuilding the driver pulley

June 21, 2020 in machine overhauling, Wörner B13

The drilling press was modified by a previous owner. As it can be seen in the picture below, someone added an intermediate pulley in the driving train to reduce the rotation speeds. What was the motor pulley became the intermediate pulley and a new single step pulley was fitted to the motor shaft. I have some doubts about the origin of this variation: would it be made at the Wörner factory after a specific requirement by a client?

Setting up the Wörner quill

May 31, 2020 in machine overhauling, Wörner B13

The Wörner quill is again on the drilling press. After being completely cleaned and disassembled, the quill rack was touched up to correct the damage that probably was made while assembling the pinion some time ago. Main bearings were replaced by a new ones. Old ones have a suspicious mark that suggest they are no plain 6006 deep grove bearings. GMN redirected me to the spanish contact Berkomat and they concluded that class P4 6005 bearings would be the right replacement.

OLDER POSTS
page 1 of 3